chickolz.blogg.se - Can you use router on a stick using ipv6 stateless

Before start up I want to give some basic information about DHCP.Īs you know DHCP uses UDP 67 and UDP 68 ports. In other words, we will see how to configure a DHCP Server with Packet Tracer Router. In this DHCP Cisco Packet Tracer router example, we will focus on DHCP Configuration in Cisco Packet Tracer.

Document and implement port security features.Router DHCP Configuration with Packet Tracer.

S2(config-if-range)# switchport mode access S1(config-if-range)# switchport access vlan 999 S1(config-if-range)# switchport mode access S1(config-if-range)#switchport access vlan 100 S2(config-if)#switchport trunk native vlan 1000 S1(config-if)# switchport trunk allowed vlan 100,200,1000 S1(config-if)# switchport port-security violation restrict S1(config-if)#switchport trunk native vlan 1000 In this pkt file, I did not configure the sub-interfaces to Router0. I am having trouble getting an IPv6 address on both PC's now that I have implemented trunking. R1(config-if)# ipv6 dhcp server R2-stateful R1(config-dhcp)# dns-server AAAA:BBBB:CCCC:DDDD::FFFF R1(config-if)# ipv6 dhcp server ipv6-stateful

R1(config-if)# ipv6 nd managed-config-flag R1(config-dhcpv6)# dns-server AAAA:BBBB:CCCC:DDDD::FFFF

These are the commands I used to set up the server, R1 = Router0: I've attached the pkt file, if you need to have a look at it. I can not get an IPv6 address on PC1, however.

Router0 is set up as a Stateful DHCPv6 server for both networks. I am getting an IPv6 address from Router0 on PC0. But, I got rid of the sub-interfaces in Router0. I started on a different pkt file, similar project, same topology as the original post.